relocation bracket issues
#1
TECH Fanatic
Thread Starter
relocation bracket issues
I started one in the suspention section but know this get way more traffic in here
https://ls1tech.com/forums/suspensio...l#post16719217
https://ls1tech.com/forums/suspensio...l#post16719217
#3
TECH Fanatic
iTrader: (16)
I had the same issue. My pass side relocation bracket sat crooked as well. I used a hammer and tapped it up a bit. Then I just used my impact gun to tighten it up. IIRC it is still sitting on a slight angle. I wouldn't worry about it too much. And I know my rear axle isn't bent.
#4
TECH Fanatic
iTrader: (2)
Join Date: Dec 2010
Location: Oklahoma
Posts: 1,084
Likes: 0
Received 0 Likes
on
0 Posts
I would take it off and measure from the one side top hole to the bottom hole on the opposite side(criss-cross). Then compare that measurement to the exact opposite. If they are the same, then the two side pieces are square and you shouldn't worry.