Drill mod/Bleeding method
#1
On The Tree
Thread Starter
Join Date: Jul 2006
Location: Alabama
Posts: 127
Likes: 0
Received 0 Likes
on
0 Posts
Drill mod/Bleeding method
Rather than bench bleeding the line and then bleeding it again after you install it on the car is there any reason you couldn’t open the bleeder once the line is attached to the tranny and use a VAC? Am I missing something here?
Thanks for any info
Thanks for any info
#2
wrencher
iTrader: (2)
Join Date: Aug 2002
Location: Chicagoland
Posts: 4,762
Likes: 0
Received 0 Likes
on
0 Posts
I would still bench bleed it just to get the debris from the drilling. Just in case the flushing didnt get it all after it was drilled out.
It is pretty simple to bench bleed it. Then vacuum it out in car.
It is pretty simple to bench bleed it. Then vacuum it out in car.