Cape T/A

I actually did this a few months back, but I figured I would share it.

I added a progressive nitrous controller, fuse block, and worked a electric cutout into my switch panel.


My pile of parts



Im pretty picky (or crazy) about some things so first I drew out a wiring diagram. It helped out a bunch though when I was actually doing the wiring.



This is while is was straitening out the old wiring mixed with my new parts.



I made this plate of aluminum to fit in the glove box to mount everything to since I didnt want to drill holes in the actuall glove box.



My switch panel wired up



Some of the wireing done and labeled



The wiring all done





I was really wanting to get the microedge+ but I they appearantly quit making them shortly before I ordered my parts, so the next cost efective progressive controller I could find was the NOS mini progressive controller, it also has a dual stage feature.

the crusty pirate

iTrader: (2)

Your attention to detail is awesome. Looks great dude.

Cape T/A

Thanks! It actually didnt come out as neat as I had hoped for, but fitting all those wires neatly into that small of an area is tough!

a4ls2goat

Looks like a headache..lol..
Good work man!

Cape T/A

well it took me 3 or 4 nights to do it all, lol

wws699

iTrader: (3)

Nice job! And nice schematic

Chris@NitroDaves

Extremely nice Re-Wire job!!!!!!!!!!

Cape T/A

Thanks a lot!

Cape T/A

Thanks! It was my first time making a wiring diagram, didnt turn out too bad, took me some time though.

CNTLSE 1

iTrader: (11)

Where did you get the fuse block and some of those parts? This is exactly what I want to do

Sales1@Texas-speed

Great job Nathan!

krissoto

iTrader: (3)

very nice buddy, I think u did a fantastic job.

99 PROBLEMS

iTrader: (47)

WOW! the is some kick *** wiring!!!!!

Cape T/A

I got the fuse block from auto zone, and the terminal strip (which I used for my grounds) from radio shack, they had a jumper strip for it so I jumpered it all together and ran my main ground right in the middle of it. The labels I made for the wire are a heat shrink tube, I printed those off of a Kroy labeler which I have access to at work.

CNTLSE 1

iTrader: (11)

Thanks for the info. What is the big box hanging out of the compartment?

Cape T/A

Its my N/A - N20 switch. My tuner wired that up to my ecu, I believe it uses a resistor to trick the computer into thinking the engine is running hot so it pulls timing when the switch is on. My tuner has it set to 8* of timing I believe. Its also wired in series with my arming switch so the nitrous will not activate with out it turned on.

Cape T/A

Thanks a lot sir!

If only it would run as good as yours!

I do what I can!

CNTLSE 1

iTrader: (11)

gotcha so basically your running a timing a twister type box and a the controller that acts as a window switch?

Cape T/A

correct.

Z284U2TRY

iTrader: (5)

Nice clean install.
Do you have relays to drive the noids or is that box enough?