Pacesetter Ceramic Coated Longtube Headers - SOLD
09-12-2013, 09:34 PM
#1
TECH Fanatic
Thread Starter
iTrader: (26)
Join Date: Mar 2010
Location: Milledgeville, GA
Posts: 1,909
Likes: 0
Received 0 Likes
on
0 Posts
Pacesetter Ceramic Coated Longtube Headers - SOLD Category: Engine - Exhaust
Price: $160
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): GA
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine
Located in middle Georgia. PM or text (478) 363 - 2126.
Thanks for your interest, Jason
Last edited by 1961ba427; 09-19-2013 at 07:10 PM.
09-12-2013, 09:37 PM
#2
TECH Fanatic
Thread Starter
iTrader: (26)
Join Date: Mar 2010
Location: Milledgeville, GA
Posts: 1,909
Likes: 0
Received 0 Likes
on
0 Posts
The pics above show one primary tube that has scraped the ground and is flattened slightly. This is very common as any of you with longtubes know and will not hurt anything....the others are all in good shape. They aren't bent up. Run them as is or blast them and have them recoated.
09-15-2013, 01:53 PM
#3
TECH Fanatic
Thread Starter
iTrader: (26)
Join Date: Mar 2010
Location: Milledgeville, GA
Posts: 1,909
Likes: 0
Received 0 Likes
on
0 Posts
How about $180 shipped to the continental US ? Maybe less if you are much closer to GA.
This is over $100 cheaper than plain painted pacesetters and I guarantee the painted ones will look worse after a few thousand miles. Most of the coating that is coming off would be out of site from the engine compartment.
This is over $100 cheaper than plain painted pacesetters and I guarantee the painted ones will look worse after a few thousand miles. Most of the coating that is coming off would be out of site from the engine compartment.
09-16-2013, 08:19 PM
#5
TECH Fanatic
Thread Starter
iTrader: (26)
Join Date: Mar 2010
Location: Milledgeville, GA
Posts: 1,909
Likes: 0
Received 0 Likes
on
0 Posts
They are actually listed on Ebay right now, but there are almost 6 days left to go with no bids yet. If you want them you can send me a deposit and I'll mark them as pending on here and stop the auction. Just let me know soon because once someone bids I won't be able to stop it.
09-16-2013, 08:41 PM
#7
TECH Fanatic
Thread Starter
iTrader: (26)
Join Date: Mar 2010
Location: Milledgeville, GA
Posts: 1,909
Likes: 0
Received 0 Likes
on
0 Posts
No....just where they bottomed out and bent slightly. If you look at the pic named "LS1j" it shows a good close up shot of where the tube is bent and you can tell it isn't cracked. The pic before it, "LS1i" shows that same area just before the collector from the side angle so you can tell it is not bent bad enough to restrict flow. In fact it is hardly noticeable from the side angle shot.