Drag Race brakes, willwood
#1
Drag Race brakes, willwood
Category: Racing Parts
Price: $400
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO, 04+ Cadillac CTS-V, 67-92 Chevrolet Camaro, 67-92 Pontiac Firebird
Location (State): NY
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6, LT1/LT4, Small Block, Big Block
LS Engine?: Fits LS Engine
http://www.wilwood.com/BrakeKits/Bra...%20Brake%20Kit
Selling my used Willwood rear Brake Kit. Has dynalite forged caliper, large but thin vented rear rotors and what makes these so nice is they have a internal parking brake inside the rotor hat, great for a street car. These are lighter then stock breaks, I forgot the exact numbers I think it was 11pounds a side and 22 or 25 total. Everything works great, no leaking, rotor are not warpt. Selling them because I went to even lighter racing brakes without a parking brake. I dont think these are sold as Drag brakes but they work great for that. They stop better then stocks too. 12.2" rotors. They are drilled for diffrent wheel stud size. I ran them on stock 12mm studs and 1/2 they are drilled and slide right over both. I think the 3rd size is for 5/8 but never tested it. One time I put the rotors on the bigger holes, so the didn't center perfectly snug on the studs. So they rubbed on the caliper bracket/backing plates (they fit tight inside the rotor hat) so it wore off some of the anodize on the bottom of the caliper braket/backing plates, and changed the color a little, as shown in the pics.Had to just file off the burr on the end were it was rubbing and it was fine after that. Dose not affect the breaks just cosmetic were it rubbed a little.
I bought these on a 12bolt rearend off a build that was parted out. I dont thing they was used, or any used a few times. I ran them on my 10bolt, then on my s60 for a few years. But that have been sitting in my garage for about 2 years. Took these pics the other day. The outside of one rotor has some surface rust for them sitting, but the pad should wipe it off 1st time. Same if any brakes sit after getting rained one without driving the car for a few days. Pads ahve lots of meat.
Another and probably the best thing is the fit almost any wheel. They have TONS of caliper room, big rotors and fit 15x10s no grinding.
Also fit stock rims too
Kits sells for $650-750ish new.
Looking to get $400 shipped US mainland.
Trending Topics
#8
comes with everything in the pics. The willwood brake kit, I dont know the exact part number this is on there website. But its the soild rotor, black calipers, Forged Dynalite Rear Parking Brake Kit. I used my stock E brake cables, and stock brake lines with new end fittings.
make a offer, asking $400 shipped from rochester NY
make a offer, asking $400 shipped from rochester NY