JY 5.3l lm7 th400 microsquirt mls studs ls9 cam
#1
JY 5.3l lm7 th400 microsquirt mls studs ls9 cam
Category: Engine - Complete Motors
Price: $2200
Location (State): WI
Item Condition: Used
Engine: LS1/LS6
LS Engine?: Fits LS Engine
heads are 862 casting. clean MLS shave, new 2.0 intake valves, new BTR dual .660 springs with steel retainers , new seals and keepers
Alper motorsports head studs
GM MLS head gaskets
new oil pan gasket
summit single roller adjustable timing chain sorry it has a double roller not a single
new front cover gasket
New GM ls9 zr1 camshaft
Microsquirt ecu , stand along harness that is all wired up , you would have like 6 wires to hook up to make run.
Or I can set up a stock harness/pcm to be used as a stand alone, ether one your choice.
Asking $2200 also have ls1 intake and New Camaro water pump with truck pulley for $300 extra.
Thank you
Donnie
if you would like, you can reach me at 414-554-7805
Picture's are of my 4.8l with ls1 intake , both engines look about the same.
Last edited by catchumdaylee; 12-26-2013 at 08:16 AM.
#3
Yes the price would go down with out the Microsquirt and NO the price doesn't include shipping.
I should also state all the new parts were just added, The motor has never seen boost and has never been driven on the new parts.
I should also state all the new parts were just added, The motor has never seen boost and has never been driven on the new parts.
Last edited by catchumdaylee; 12-17-2013 at 06:30 PM.
#6
I have had a lot of interest in just the microsquirt and drop on harness, I have two microsquirts both new, one with a harness already made. I would need $650 shipped plus paypal fee's for the one with the drop on harness. The other I could make to any length and any injector plug you would like. The harness already made just has standard wire loom, every connection is soldered and heat shrinked. And new harness would have braided wire loom with heat shrink and soldered joints. The braided loom looks much nicer then the standard loom and is more flexible.
If you would like pictures just shoot me an email/text or check back here in a few days.
If you would like pictures just shoot me an email/text or check back here in a few days.
#7
I am doing a similar build and I was wondering about your ac setup. It looks like your using the truck ac bracket, correct? Is there any other pulleys needed to make it work with the camaro accessories? Thanks