C10Lm7

Category: Accessories
Price: $200
Part Fits: 2010+ Camaro
Location (State): AL
Item Condition: Brand New
Engine: LS2/LS3/LS7/L92/LS9
LS Engine?: Fits LS Engine

Pistons have low miles on them. $200 local sale Sacramento Ca
92/LS3 Chevy PowerPak Piston & Ring Kit
Forged 4032 High Silicon Aluminum Alloy
Bore: 4.070"
Pin Diameter: 0.927"
-8cc Inverted Dome Volume
Compression Ratio @70cc: 10.9:1

LsXRs

iTrader: (42)

Fit stock rods?

C10Lm7

Yes but only gen iv floating pin rods.

ondatrack

iTrader: (15)

Stock rods don't have .927 pins, they use a .945 pin. i It would take an aftermarket rod to use these.

C10Lm7

gen 3 rods have a .945 pin and are a press fit. These pistons do NOT work with gen 3 rods. Gen 4 rods are .927 with floating pins and will work.

ondatrack

iTrader: (15)

I am not trying to be difficult but trying Make sure someone does not make a mistake. The pins as measured in my LSA and 3 LS2 rods are all .945 floating. Common misconception and I am sure an honest mistake on your part. Many on this board don't do there own research and take the word of a good intentioned seller without doing their own due dillegence. Here is a link http://www.ls2.com/boggs/LS2/engine/...calspecs03.JPG

C10Lm7

Yeah your right. I was not aware of that! Anyways these pistons need aftermarket rods.

C10Lm7

Bump $150! Come get em!

ColeGTO

iTrader: (3)

Do you know the part number for these? I just want to make sure these are the correct compression height for a stock 3.622" stroke and I assume a 6.125" aftermarket rod.


Thanks,
Cole