nitrorocket

iTrader: (12)

Looking for a used clutch & flywheel to hold 850 rwhp.

RedHatRdRacer

iTrader: (25)

your going to want something else, i have a spec 5 and make slightly below 650rwhp on motor and it will not disengage fast enough for me

nitrorocket

iTrader: (12)

Are you sure it's the clutch and not the hydraulics??

RedHatRdRacer

iTrader: (25)

I have an adj, master clyd and the drill mod... Its the pressure plate i am sure

nitrorocket

iTrader: (12)

Anyone???

Gimp98TNT

iTrader: (21)

FYI, i used this clutch for a whole season behind a a 346+N2O making 650rwhp, and cutting 1.40 60fts. Worked great. Same clutch is now behind a 750rwhp turbo car, and its still going strong.

And a bump for ya.

nitrorocket

iTrader: (12)

Thanks for the reply!!

MT POKT

iTrader: (10)

I have a low mile RAM VDS w/ 910 disck and billet flywheel (fresh resurface) I'll let go for 450 + shipping. It was too much clutch for my weekend warrior. 4-6K miles, tops. Fyi, this clutch is SFI approved and is completely rebuildable. You can send his to Ram and have the friction material replaced and the pressure plate resurfaced. I believe it was around 250, which is a hell of a lot cheaper than buying a new clutch every time. LMK.

Thanks
Greg