How did you run your LM-1 Wide Band to the inside of your car?
#6
11 Second Club
iTrader: (8)
Join Date: Jan 2002
Location: SILSBEE TX
Posts: 1,782
Likes: 0
Received 0 Likes
on
0 Posts
I remover the right front seat and the side molding, pulled back the carpit , drilled a hole in the floor ,ran the wire over to the side , and up to the front across to the center and back to the console replaced the carpit and molding
Trending Topics
#10
TECH Addict
iTrader: (10)
Join Date: Jun 2004
Location: Commerce Twp, MI
Posts: 2,918
Likes: 0
Received 0 Likes
on
0 Posts
I've got my sensor in the driver's side header, ran the wire up through the hood, and into the cabin through the driver's side door just behind the mirror. The weather stripping is pretty forgiving. Since it's not a permanent install, I figure it's ok.
#14
12 Second Club
iTrader: (2)
Join Date: Oct 2003
Location: So Cal
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by SpdFrk1990
Where did you guys get your 12v power source from trying to decide where to hook mine up. Just got my NGK in the mail today looks like a very nice piece.
#17
TECH Resident
iTrader: (8)
Join Date: Dec 2001
Location: DFW
Posts: 905
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by SSpdDmon
I've got my sensor in the driver's side header, ran the wire up through the hood, and into the cabin through the driver's side door just behind the mirror. The weather stripping is pretty forgiving. Since it's not a permanent install, I figure it's ok.