Loud Mouth F/S
Loud Mouth F/S EXHAUST HAS BEEN SOLD
I have an LM1 with a Flo-Pro twister welded in place of the LM resonator for sale. The exhaust comes apart in the original places.
here is Flo-Pro's homepage http://www.flopro.com/FloPro.htm and here is the page with the muffler that is in the LM1 system i have http://www.flopro.com/Twister.htm. the specific muffler in the LM is part number 41777, its under the F4 series on the top right.
i had the Flo-Pro installed when i installed long tubes and ORY without cats. it sounds similar in pitch to an LM1 on an ls1 with stock manifolds and y-pipe but i could hear more of each cylinder firing, almost like a borla system. sounds pissed at higher rpm's
.
picture 8 is showing the cut i had to make to the pipe in picture's 3, 4 and 5 to separate it from from the pipe in picture's 1 and 2. i tried heating it, twisting it apart and even tapping it with a hammer but couldnt get it to budge, so i had to cut that little slit. i cut it far enough forward so that when the pipes are connected there will be about 1 inch of overlap away from the cut i made. for some reason i couldnt get very good shots of the tips, i will try again tomorrow in natural light.
my asking price is $160 plus shipping, and i am willing to negotiate but not trade.
1.
2.
3.
4.
5.
6.
7.
8.
I have an LM1 with a Flo-Pro twister welded in place of the LM resonator for sale. The exhaust comes apart in the original places.
here is Flo-Pro's homepage http://www.flopro.com/FloPro.htm and here is the page with the muffler that is in the LM1 system i have http://www.flopro.com/Twister.htm. the specific muffler in the LM is part number 41777, its under the F4 series on the top right.
i had the Flo-Pro installed when i installed long tubes and ORY without cats. it sounds similar in pitch to an LM1 on an ls1 with stock manifolds and y-pipe but i could hear more of each cylinder firing, almost like a borla system. sounds pissed at higher rpm's
.picture 8 is showing the cut i had to make to the pipe in picture's 3, 4 and 5 to separate it from from the pipe in picture's 1 and 2. i tried heating it, twisting it apart and even tapping it with a hammer but couldnt get it to budge, so i had to cut that little slit. i cut it far enough forward so that when the pipes are connected there will be about 1 inch of overlap away from the cut i made. for some reason i couldnt get very good shots of the tips, i will try again tomorrow in natural light.
my asking price is $160 plus shipping, and i am willing to negotiate but not trade.
1.
2.
3.
4.
5.
6.
7.
8.
Last edited by RA4926; Jul 16, 2008 at 11:17 PM.
) and paypal accepted? 
