Installed Raptor Shift light, got a question
#1
On The Tree
Thread Starter
iTrader: (5)
Join Date: May 2005
Posts: 140
Likes: 0
Received 0 Likes
on
0 Posts
Installed Raptor Shift light, got a question
it was a pretty easy install, I hardwired my V1 at the same time ... but whats goin on is if i have it set at say 5300, when i'm in 1st at WOT it seems to go off at like 4k ... if i go slow through 1st it won't go off till 5300 like it is set to ... what would cause this?
here is the install pic of where i put it
here is the install pic of where i put it
#6
TECH Senior Member
Join Date: Apr 2004
Location: Texas
Posts: 6,157
Likes: 0
Received 0 Likes
on
0 Posts
which wire did you use to get the rpm reading? (hopefully the pcm)
are you sure your not spinning the tires? (is it all gears or just first?)
did you take the grounds to BARE metal (very important)
are you sure your not spinning the tires? (is it all gears or just first?)
did you take the grounds to BARE metal (very important)