1WKDMRM

I just installed BMR non-adj LCA's and PHB both have poly bushings. After install I noticed the Rear end sitting about a half inch to the drivers side and pushed to the rear of the car about the same. How would I go about fixing the problem besides buying adj LCA's and PHB?

Thanks

tigearl12

iTrader: (1)

Did u measure before the change? And now its different? Just did same thing to my ws6 today and it lined up perfect . Just tested and it hooked better and stayed strsight with 430rwhp and drag radials loved it.

Jr.Samples

I installed the same non adjustable BMRs on mine but did not notice anything "off". I have not drove it either.

BMR Sales2

iTrader: (40)

Is your vehicle lowered or factory ride height? The PHB you received should be the same length as the factory one so you can check that and verify the PHB you received is the correct length.