Yup motor is toast!
#6
Not sure what im gunna do yet, was already quoted 7400 for a built shortblock, parts and labor,gaskets ect...Or i f the block and crank are ok i might just do the pistons and rods, but idk yet, gotta think it out and do it right..Its been gone for a while though i think, it just worsened over time...
Trending Topics
#13
had about three bad ones on the passenger side, i believe it was the #6and 7 that were the worst,92,and 112..compared to the good ones that read 185...Lol i was racing those built400ci motor guys on a hurt motor and was still right there with them!!!..lol..But when it back up i will run the whipple for a lil while, then can you say twin turbos?
#14
TECH Apprentice
iTrader: (4)
Join Date: Jan 2008
Location: Califronia
Posts: 350
Likes: 0
Received 0 Likes
on
0 Posts
Not sure what im gunna do yet, was already quoted 7400 for a built shortblock, parts and labor,gaskets ect...Or i f the block and crank are ok i might just do the pistons and rods, but idk yet, gotta think it out and do it right..Its been gone for a while though i think, it just worsened over time...
#15
#16
So what do you guys think, if the block and crank are fine, should i just re use it and do rods and pistons? I know this aint a SVT forum, but i know some of you gear heads know motors in general and i would appreciate your input, thanx in advance!
#17
Teching In
iTrader: (11)
Join Date: Jul 2008
Location: so cal
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
sorry about ur motor... i know how that feels.. make sure you know who is building your motor bc there is some fucked up engine builders out there.
can build u a 9 sec motor for that price.. 351 w tho
can build u a 9 sec motor for that price.. 351 w tho
#20