Jet Hot Y Pipe W/ Removable Cats
#1
Teching In
Thread Starter
iTrader: (2)
Join Date: Jan 2008
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
Jet Hot Y Pipe W/ Removable Cats
IF YOU ARE INTERESTED, IM GOING TO CMS "RYAN" HES GOING TO TAKE IT OFF FOR ME THIS FRIDAY.
Used 2 weeks but decided to get a custom made one.
For 98-02 Camaro or Trans Am
$300
619-207-6426
This Jet-Hot Y-pipe works with Jet-Hot, Hooker, and Thunder Racing's LS1 F-body Headers. Features a 3" diameter pipe, removable high-flow cats, and all necessary hardware. Has rear O2 bungs already welded in, no simms required! Comes coated inside and out with Jet-Hot's Sterling finish! Tested in Philadelphia with Jet-Hot's LS1 Headers and passed an emissions test
Used 2 weeks but decided to get a custom made one.
For 98-02 Camaro or Trans Am
$300
619-207-6426
This Jet-Hot Y-pipe works with Jet-Hot, Hooker, and Thunder Racing's LS1 F-body Headers. Features a 3" diameter pipe, removable high-flow cats, and all necessary hardware. Has rear O2 bungs already welded in, no simms required! Comes coated inside and out with Jet-Hot's Sterling finish! Tested in Philadelphia with Jet-Hot's LS1 Headers and passed an emissions test
#2
Banned
iTrader: (8)
Join Date: Jun 2007
Location: san fernando valley, california
Posts: 3,093
Likes: 0
Received 1 Like
on
1 Post
yo watsup man, will you be available this week so i can come pick up the stuff i wanted? i was thinking maybe thursday or saterday? anytime, i have to travel in the morning so i get there around 12 to 1 o clock and please send me the pics asap so i can come this week man thanks sorry for any trouble
Last edited by ae13291; 03-18-2008 at 01:56 PM.
#3
TECH Fanatic
iTrader: (15)
I have this y-pipe but I don't use the cats. I have read some complaints that it's hard to install, but that's relative (I did it, so it can't be hard). It tucks up real nice since it has multiple pieces, which allows for great adjustability.
Use band clamps like the preformed Torc-tite and don't fully crank them down until you have it set.
If I had to do it again, I would still get this y-pipe.
Use band clamps like the preformed Torc-tite and don't fully crank them down until you have it set.
If I had to do it again, I would still get this y-pipe.