xXxSilveradoxXx

iTrader: (5)

Yes they are

ramairjohn2000

iTrader: (3)

so is it possible to get them lower in the wheel well? and how much cutting waas involved and would these work for the front wheel well??????
or is anybody out there making a direct bolt on??? hmmmmmmmmmmm 6litereater>>>>>

71-Camaro-98

iTrader: (17)

Where did you find your sets?

xXxSilveradoxXx

iTrader: (5)

I'm waiting for some 335+ for my car before I get some, that was where Qcon got his.

71-Camaro-98

iTrader: (17)

OK maybe I am missing it but I dont see the name of a place to buy in your post haha.

xXxSilveradoxXx

iTrader: (5)

Engine_HP was asking if they were C6 ZO6 splash guards, I told him yes. Then you asked me where I got mine and I told you that I didn't have any!

I did however post up a direct link to the splash guards on PartsTaxi.com Direct Link to the Splash Guards

71-Camaro-98

iTrader: (17)

Thank you for the clarification.

camarox302

iTrader: (2)

I finally got ahold of a set. Has anyone else since done this or has a guide to trimming them? I'd like to modify the front set by flipping them and trim them to fit behind the front wheels since those also spray all over the bottom of my front fender.

And after checking this thread again I realized I bought the regular C6 splash guards not the Z06 ones... so i may just scrap the whole idea because the shape is all wrong and it does not stick out far enough to prevent splashing anyway. I've already spent 5 hours on just the passenger side trying to make it fit properly and it was pretty much a waste.