AC Knobs
wont work. my bro has a 95 stang too. i tried his on my SS and the rear inserts are different. i thought if they worked i could have just order the stang billet ones since they are only 20.00
The aftermarket support for 4th gen FBody interior pieces is limited unless you come up with an idea yourself that will work. I think I heard that 96-98 Grand Am ***** will fit, but I don't think that's any better than stock. I do like the MBA ones & after seeing them in a few cars I think they are about the only good option but $30 is steep for one **** when to do it right you need 4.
what if you filled in the rear cutout with bondo or whatever and then you mimicked the holes of our cars and put them on could anybody get that to work thatwould leave the possibilities almost endless. just throwing out ideas
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Thread Starter
TECH Enthusiast
Joined: Dec 2004
Posts: 678
Likes: 0
From: Louisville, Ky
Think everyone has given up on this one, though in my searching someone said that the truck ***** would work. Dunno if he meant S10/Silverado/Colorado/Tahoe or what. I have no access to anything except my wife's passat at the moment, and those definitely don't work.
The S10 ***** are clocked the same but the mounting point is flush on the S10 ***** and has a shaft on the Camaro ***** which slides into the actual control panel. Kinda hard to explain so I'll post a pic shortly.
I am not sure how common MBA ***** are...I dont think at all the shows I have been to I have ever seen (or remember seeing) another car with them. I bought a set of blue ones off the classifieds for $70 (all 4) and then spent about 12 hours sanding and polishing them.
The only thing that might work is to create some kind of adapter, although that might only work for a flush mount style ****... Basically have a fitting with the female end machined to the stock selector shaft, and the male side machined to fit the position of the new ****.
