Can someone make me a decal please!?

Reply Subscribe

Thread Tools

Search this Thread

May 14, 2011 | 09:27 PM

dynodanmanda79

Thread Starter

Staging Lane

iTrader: (3)

Joined: Jun 2008

Posts: 76

Likes: 0

From: Crestview, FL

Can someone make me a decal please!?

Not sure if this is the right place to post this but, i'm in the process of prepping my FAST 90mm intake for paint. The previous owner of this intake shaved the FAST emblem off the intake and i'd like it back! Just curious to see if someone could make a decal exactly like the FAST emblem that comes on the intake?

Thanks, Dan

Last edited by dynodanmanda79; May 14, 2011 at 10:04 PM.

May 14, 2011 | 11:35 PM

dynodanmanda79

Thread Starter

Staging Lane

iTrader: (3)

Joined: Jun 2008

Posts: 76

Likes: 0

From: Crestview, FL

I have found someone willing to cut one for me, does anyone happen to know approximately what size the FAST emblem is on the FAST 90 intakes?

Thanks again, Dan

May 15, 2011 | 10:30 PM

dynodanmanda79

Thread Starter

Staging Lane

iTrader: (3)

Joined: Jun 2008

Posts: 76

Likes: 0

From: Crestview, FL

Damn, I guess nobody has a FAST 90 anymore. I emailed FAST and they were about as good of help as asking a damn monkey! I guess not a single employee that works there has a FAST 90 and can walk out and take a quick measurement.

May 16, 2011 | 11:32 AM

Pseudonym

TECH Enthusiast

iTrader: (3)

Joined: May 2009

Posts: 578

Likes: 5

From: NJ

Its about 4-5/16" by 1-3/8" on a FAST 92. I think its the same on the 90.

May 16, 2011 | 10:52 PM

dynodanmanda79

Thread Starter

Staging Lane

iTrader: (3)

Joined: Jun 2008

Posts: 76

Likes: 0

From: Crestview, FL

Quote:

Originally Posted by Pseudonym

Its about 4-5/16" by 1-3/8" on a FAST 92. I think its the same on the 90.

Thank you very much for taking the time to find this out! It's exactly what I was looking for!

May 17, 2011 | 08:26 AM

Pseudonym

TECH Enthusiast

iTrader: (3)

Joined: May 2009

Posts: 578

Likes: 5

From: NJ

You're welcome, and good luck with the swap.

May 19, 2011 | 04:25 PM

Rebob5

TECH Regular

iTrader: (3)

Joined: Dec 2004

Posts: 441

Likes: 3

From: Syracuse,NY

Dan, Decals are all done. I wasn't sure if my cutter would cut that small because im used to doing big decals but it managed to make them no problem. Here is what they look like!!