Super-Bat

iTrader: (38)

I actually think it looks good, but am afraid it'd ONLY look good on a black Trans Am.

southpaw0314

iTrader: (5)

ive been debating on getting the gfx for the camaro and doing it for a while.

bigken

iTrader: (8)

Looks good bro I like it.

WS6_Veteran

iTrader: (6)

Give it a shot, plastic dip is really easy to spray and really hard to screw up. As long as it is a bit warm out so it will dry before it starts running you'll be good. It was about 60 outside when I did this so I used my heat gun (really far away) to make sure each layer dried.

If you don't like it you can always peel it. Im going to do a write up on the other side this weekend. Will include exactly where to tape off and what not.

creiss21

Plasti Dip FTW, I did the ceta mod also with it. Easy cheap and durable IMO

WS6_Veteran

iTrader: (6)

As I promised, finally got the other side done, little bit late because wife went into labor a week early but its finally finished.

Cleaned and waxed the car and snapped a few photos in the sun. Had to darken photos a bit because it wouldn't show with the bright sun.

Johnnystock

iTrader: (6)

Great and better than the 5th Gen for sure.

jlincks

iTrader: (3)

Well you've just gave me my new project! my skirts are looking rather bad and this would clean them up alot. GREAT JOB!!

thunderstruck507

iTrader: (18)

Looks great, I came in here expecting to hate it. Nice work

stevesfbody

Like before it looks really good