Cole Train

iTrader: (30)

Does anyone know the size of the rings i'd need to go behind the Morimoto gatling gun shrouds? i want to add white behind it but not sure what size i'll need. I have the shrouds/projectors on the way so if anyone can help me out so i can order the LEDs or rings that'd be awesome

Cole Train

iTrader: (30)

Specifically so i can get this look.

maxplusten

iTrader: (4)

retrofit source dosent have the info or specs?

Cole Train

iTrader: (30)

i didn't see any but i was looking on my phone and sometimes if the writing is small i miss it. I'll check again...

Cole Train

iTrader: (30)

appears they have a 70mm diameter. Now i just have to get people that sell the rings to tell me what the inside diameter is of all their rings... they can't seem to tell me.

Cole Train

iTrader: (30)

I decided against doing it. Requires me to mess with the shrouds and if i mess them up i gotta buy more. I'm fine with being what it is.

sweetbmxrider

iTrader: (13)

Did you ask trs? Putting them inside full size gatlings is easy. Drop them into the shroud then apply silicone to the backside so it flows onto the shroud. You can also put silicone down in the holes that aren't cut fully through if you understand me.

Cole Train

iTrader: (30)

i'll keep looking into it. Right now i just don't think i want to add 'em

sweetbmxrider

iTrader: (13)

I had one go bad so I don't even use them anymore.