93BlackZ28

iTrader: (5)

Ok i cant find my friggen camera so i tryed to find pics but it wasn't easy. In this pic below of the white T/A i have the piece circled in red. Its right by the hood latch and there will be 2 bolt that connect the bumper to the frame of the car, Simply loosen the bolts then pull up on the bracket and retighten.

Revelation Z28

iTrader: (10)

oh ok that big *** one that the latch is connected to and the washer fluid is behind.

edit: i loosened the 2 bolts holding it to the frame and it didnt go anywhere when i pulled up.

94blownz281

iTrader: (12)

kinda confused as well cause i don't think that piece moves..

93BlackZ28

iTrader: (5)

The thing that you move is a big *** bracket thats connected to the front bumper. Sorry i dont have a camera.

Revelation Z28

iTrader: (10)

is it the black one or the body colored one?

because i slid the black one up and it didnt work.

nhra-trans-am

iTrader: (103)

its the body colored one

Revelation Z28

iTrader: (10)

thats the one that wouldnt budge or anything.

nhra-trans-am

iTrader: (103)

you can just loosen the bolts for the hood latch and move the hood latch down, then tighten the bolts back.

Revelation Z28

iTrader: (10)

cant do that. my hood is perfectly lined up on the sides.

Pewterpower

You might want to think about removing the bumper cover and inspecting the styrofoam. It, too, is just clipped on, and can sag over time.

94blownz281

iTrader: (12)

our cars don't have styro foam in the bumpers... only TA's. plus his is a 94.

adman jones

This bumper gap is around 5/8 to 3/4”