tranny help !
Thread Starter
Teching In
Joined: Jun 2009
Posts: 22
Likes: 0
tranny help ! i have 02 z28 ... 3600 stall and stage 2 internals after 30 min of driveing first gear gose out then you turtn car off and restart it works again like when it ***** up and ur from a dead start it starts in 2nd and with my stall it take like hella rpms to go any were the code came up for shift solinoids but the guy who built it replaced them and this problem happend again after 30 min from replacing them same code but if i restart car first gear works again , any help ? maybew tune ? or short ? opr bad tranny , it just got rebuilt and it happend 30 min after i picked it up its my daily driver so i have to drive it like this ....
you need to tune for the stall code is likley po757 common with a high stall. solenoid is not bad. PCM is just confused. REMOVE TEST FOR THE CODE. Problem likley solved,
__________________
its hard on the 3-4 clutch to start in 3rd gear if its happening alot i would not drive
__________________
No in limp mode it starts in third. Tkae off in d3 then manual shift to 2nd you will feel it downshift you will only have 2-3 gear manually
__________________
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
