I am swapping from a m6 to th400 I was wondering what wires on the clutch pedal that you cross to make it start?

also, I have a switch panel, and a empty switch I was wondering if I ran the wires couldnt I just use the switch like the stockish setup??

thanks
ed
firebird455@onebox.com

 

You splice the lower clutch switch wires into the neutral safety switch ot make it start. Reverse lights are a different story. Sorry, I got a little confused with your question about the switch panel. What are you asking about?

 

the shifter that I have doesnt have the neutral saftey switch.

So I was wondering if I could just run the wire to a panel where I allready have switches?

I dont really care about the NSS, so I was wondering the switch panel is allready in place.

also is there only one wire down there by where the clutch pedal plugged in? I honestly dont remember

thanks
ed
firebird455@onebox.com

 

You could just take the plug out of the sensor and just splice them together. Be smart and don't hit the starter while it's running (I know, duh)!