1BADLS1tuner

iTrader: (5)

Hey guys i have come across an 07 4.3 van 4l60e... will it bolt to a 5.3?

It has the 12 oclock bolt hole, and 6 bolt tail housing.....

are they the same as the fbody trans (minus the torque arm mount)????




Thanks for any help guys!!!

1BADLS1tuner

iTrader: (5)

normally you guys are on top of this kind of stuff! lol

I have searched everywhere and i cant find if it will work behind a 5.3 or not....

zgp

it is hard to see the tag on the converter but if that is a TLCX Code, then it is a 300 mm converter and will work in your vehicle.

01ssreda4

iTrader: (96)

Case is the same, I can tell by looking at it. So yes it will bolt up physically. Electronics and/or input shaft could be different though.

74novacustom

i bolted this same transmission to my 6.0. But you will need a hughes or similar crank spacer with your flexplate. you will also have to elongate the converter bolt holes a little inward for them to fit.

But i just had to pull the trans because the input shaft broke due to too much power. but the trans was completely built. this time im putting in a hardened input shaft, it will be worth the money.

74novacustom

also i had to replace the electronic piece that goes over the shifter linkage shaft to fit my harness.