stall converter ?????
Thread Starter
12 Second Club
Joined: Oct 2011
Posts: 217
Likes: 0
From: Seaford,DE
stall converter ????? got my built 4l60 done and ordered my yank ss4000 last night will it be ok to run the converter before doing the cam. im probably going to do a forged 370 with ls3 heads and 230 236 duration at 114lca.
Moderator
Joined: Aug 2010
Posts: 7,323
Likes: 529
From: Ann Arbor, MI
Same question was answered here this week:
https://ls1tech.com/forums/automatic...-new-tune.html
In short, if the trans doesn't go into limp mode, you should be OK.
Obviously after changing the cam, you MUST get a tune.
https://ls1tech.com/forums/automatic...-new-tune.html
In short, if the trans doesn't go into limp mode, you should be OK.
Obviously after changing the cam, you MUST get a tune.
Yes, you'll be fine running the converter before installing the other goodies. I would recommend a tune though. That is a high stall and will have major effects on lock up, and shift points. Without a tune, I would suspect you'll set off an SES code.
