lsrob90

I just bought a transmission for my swap and it had a fixed yoke where it is bolted on to the output. I obviously want a slip yoke but what do I need? I know this has been dealt with before but I still don't quite understand this as i know little to nothing about transmissions. Simple question: Do I need to swap out the output shaft? I sure hope not, if not, I just buy the correct slip yoke for my setup(o-ring location or something)?

Sorry for the probably repeated question but this transmission has me in a pickle as it had ice in it and I payed too much for it as it is. Just want some relief here haha.


Much thanks in advance

Q

iTrader: (18)

start at post #13.

https://ls1tech.com/forums/automatic...ml#post7080256

lsrob90

That's exactly what I have! Thanks! Just need to find the proper th400 slip yoke he was describing.