LS 4l60e connector voltages

Reply Subscribe

Thread Tools

Search this Thread

Sep 9, 2017 | 09:05 AM

95wannabe

Thread Starter

TECH Enthusiast

iTrader: (20)

Joined: Aug 2009

Posts: 505

Likes: 13

From: Maryland

LS 4l60e connector voltages

I'm piecing together a LQ4/4L60E in to a '95 Camaro. I've put a few miles on it and it feels like the converter unlocks and locks in any gear when throttle is applied. From a dead stop if I nail it, it revs to the moon at the 1-2 shift. And would probably act the same at 2-3 I just never held it.
At light throttle cruise, it will lock in OD but with any more throttle it immediately unlock/(slips?). Feels like it does this in any gear.

I found this dwg online. Unknown if LS or not.
Disregard the red highlighted U. That was already on the dwg.

Can anyone tell me what I have for voltages are correct? Key on, engine off.
A - =
B - =
C - 11v
D - =
E - 12v
F - =
G - =
H - =
J - =
K - =
L - 5v
M - grd
N - 10v
P - 10v
R - 10v
S - =
T - =
U - =

Last edited by 95wannabe; Sep 9, 2017 at 10:43 AM.

Sep 12, 2017 | 07:46 PM

clinebarger

TECH Fanatic

Joined: Jan 2015

Posts: 1,114

Likes: 33

From: Fort Worth, Texas

I'm not sure what your trying to do here??

If your using a "Breakout" method....Everything connected, Key on...........

Pin U should have Voltage if this is a PWM 4L60E, The other solenoids could/can be pulled Low by the PCM.

Sep 12, 2017 | 09:31 PM