A4 problem wont lock up on dyno
Thread Starter
10 Second Club
Joined: Jul 2004
Posts: 156
Likes: 0
From: San jose
A4 problem wont lock up on dyno i am having problems i have had this freshly built 4l60e for a week of driving and 1 track day i added fast90/90 to my new set up but on the dyno my torque converter does not want to lock up it is a vig3600 it isn't the torque converter because i sent it to vig and got it refreshed and there was no problem what do you guys think is happining.my mods are in my sig
Restricted User
Joined: Apr 2004
Posts: 377
Likes: 0
The lighter and looser the converter, the more
likely that you would see (false?) misfires and
have the PCM refuse to lock it when told.
You should still be able to ground the lock solenoid
line and force it though.
Some converter clutches are not really capable of
holding at WOT. I don't know about this specific
one.
likely that you would see (false?) misfires and
have the PCM refuse to lock it when told.
You should still be able to ground the lock solenoid
line and force it though.
Some converter clutches are not really capable of
holding at WOT. I don't know about this specific
one.
Thread Starter
10 Second Club
Joined: Jul 2004
Posts: 156
Likes: 0
From: San jose
well my tuner Rick@synergy tried to manually lock the converter with a switch and would lock for a couple of seconds then it would unlock again someone told me sometimes its because of a big cam or just misfireing and not allowing the converter to lock.but my cam isin't to big only a 232/234 590 112. misfireing i don't know if it is. what do you guys think? should i try anything new before i put it on the dyno again and atemped too.
