TH400 install
Thread Starter
Teching In
Joined: Oct 2006
Posts: 14
Likes: 0
From: Hampton,Va.
TH400 install I want to put my TH400 TCI trans with a 4,000 rpm stall into my 2000 WS6 behind a Texas Speed 402/ls2.Its currenlty in my 71 Formula behind a 468 BBC.My questions are as follows.
1-What flywheel will I need?
2-Will the stock 6 speed mount work?.I've heard you can turn it around.
3-Will the driveshaft have to be cut,& if so do most cut & weld the aluminum
shaft or replace the shaft with steel one thats cut & welded?
4-Trans cooler I asume is like any car,locate in a air flowing area.
5-Will the pcm have any problems with the absense of speed sensors & any
switches that are not hooked up?
6-Am I leaving anything out?
1-What flywheel will I need?
2-Will the stock 6 speed mount work?.I've heard you can turn it around.
3-Will the driveshaft have to be cut,& if so do most cut & weld the aluminum
shaft or replace the shaft with steel one thats cut & welded?
4-Trans cooler I asume is like any car,locate in a air flowing area.
5-Will the pcm have any problems with the absense of speed sensors & any
switches that are not hooked up?
6-Am I leaving anything out?
