4l60 question
Thread Starter
Staging Lane
Joined: Jun 2006
Posts: 63
Likes: 0
From: New Lenox, Il.
4l60 question Just had a new 4l60 built for a 99 camaro. Put in a known good yank 4000 stall, and the car didn't move. Put the scanner on it, and it had no input shaft rpm. Took the trans back out to find the splines on the new input shaft worn down almost all the way. Is there any reasonable explanation for this? thanks
I would have to beleave there is some issue with that converter, You said it was in a T/A but what year is each car?
__________________
Well there wasnt a mismatch there but the converter is still suspect, Is there any way you could take picks of this splines that are messed up on the trans now?
__________________
Trending Topics
Oh and was looking at your OP and you say you put a scanner on and there were no input shaft rpm. And there wouldnt be since the 4l60e has no input speed sensor. It only sees engine RPM and OUTPUT speed just FYI .
__________________
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
