4l60e to th350

Reply Subscribe

Thread Tools

Search this Thread

Jan 28, 2008 | 08:24 PM

bonnarls1

Thread Starter

Launching!

iTrader: (20)

Joined: Dec 2006

Posts: 219

Likes: 0

4l60e to th350

on a 98-02 with a 4l60e,when you change to a th350 did anyone have to get a drive shaft made, i have my stock drive shaft in and it's to short,and i get a vibrtion when i'm driving.

Jan 28, 2008 | 08:30 PM

troy10

Teching In

Joined: Jan 2008

Posts: 4

Likes: 0

not sure.but thats what iwanna try..call b&m,or tci,maybe they have some input..good luck..

Jan 28, 2008 | 09:30 PM

Top Fuel

10 Second Club

iTrader: (8)

Joined: Nov 2001

Posts: 838

Likes: 0

From: NW Indiana

I gotta new one just because i didnt want to use the brake with a stock one. The new one is a little longer, dont remember how much.

Jan 28, 2008 | 09:46 PM

bjamick

TECH Veteran

iTrader: (31)

Joined: May 2006

Posts: 4,218

Likes: 3

From: Birmingham AL.

You need to get a TH350 with a 9" tail shaft in order to use your stock driveshaft. If you got the short tailshaft then you will have to have one made.

Jan 29, 2008 | 07:49 AM

DanZ28

10 Second Club

iTrader: (5)

Joined: Nov 2001

Posts: 3,412

Likes: 0

From: Cali/Bay Area

Yes, short tailshaft will need a new DS.

Jan 29, 2008 | 09:06 AM

bonnarls1

Thread Starter

Launching!

iTrader: (20)

Joined: Dec 2006

Posts: 219

Likes: 0

i have the 9" tail housing but my driveshaft only goes in about 1 3/4".

Jan 29, 2008 | 07:50 PM

LT1hp

Teching In

Joined: Jan 2008

Posts: 5

Likes: 0

From: Louisville

need answers

hey what did you do about the kick down cable,and speed-o-cable and does it set a check engine light?????because that tranny that came out is ran by ecm thanks for your help