converter for boost
#1
On The Tree
Thread Starter
iTrader: (6)
Join Date: Oct 2007
Location: Arkansas
Posts: 111
Likes: 0
Received 0 Likes
on
0 Posts
converter for boost
i'm looking for a converter for my turbo setup, i have a art carr 3200 but i think its blowing through the converter. i have 4.10 gears and a turbo 350 trans so my mph is limited but when i'm at 75% throttle my mph is around 90 to 100 mph when it hits the rev limiter in drive, and when i'm at 50% throttle my mph is around 105 to 115 when it hits rev in drive, so basically when boost comes in i'm hitting the rev limiter really fast. I'm thinking about sending this one back and having them tighten it up, what does everybody think?
#5
Thanks for the additional info...
I would recommend a stall speed in the 2,600 - 2,800 range. It may even need to be adjusted once you run it again. It is not uncommom to see that in forced induction apps.
Good Luck... if you would like to discuss the converter in detail give me a call.
g
I would recommend a stall speed in the 2,600 - 2,800 range. It may even need to be adjusted once you run it again. It is not uncommom to see that in forced induction apps.
Good Luck... if you would like to discuss the converter in detail give me a call.
g