Im doing a TH350 conversion on my LT1 car, will the stock driveshaft work if I use the 9in tailshaft version and have a M12-bolt?

Ive read alot that it will work with a stock style rearend, but cant find anything about the aftermarket rearends.

 

did you read my faq?

the trannsmissions are very close to the same lenght. if it works now, why wouldnt it work with another tranny of the same lenght

 

Not sure, but I do know you will have to change u-joints to make it work with a moser 12 bolt

 

It will work good enough to drive it, but when you hammer it there is too much flex. It doesnt go into the tailshaft enough. I broke 2 tailshafts learning the hardway. I had Denny's make a custom fit 3.5" aluminum. It does cost though.