Stabilitrak / Traction Control Questions...
#1
TECH Fanatic
Thread Starter
iTrader: (8)
Join Date: Jun 2010
Location: Helendale
Posts: 1,921
Likes: 0
Received 0 Likes
on
0 Posts
Stabilitrak / Traction Control Questions...
I have check the FAQ, and nothing. And did a half assed search on here, but nothing as well. So...
Just about everytime I hit a bump, I get the magical "Service Stability System" on the DIC. I am pretty sure that it the speed sensor(s) in the *** end of the car.
The questions are...
Would my assumpion correct, if not, what could it be?
How do I "fix" the Sensor(s) (i.e. where are they and all that ****)?
Thanks in Advance.
Just about everytime I hit a bump, I get the magical "Service Stability System" on the DIC. I am pretty sure that it the speed sensor(s) in the *** end of the car.
The questions are...
Would my assumpion correct, if not, what could it be?
How do I "fix" the Sensor(s) (i.e. where are they and all that ****)?
Thanks in Advance.
Trending Topics
#11
I have check the FAQ, and nothing. And did a half assed search on here, but nothing as well. So...
Just about everytime I hit a bump, I get the magical "Service Stability System" on the DIC. I am pretty sure that it the speed sensor(s) in the *** end of the car.
The questions are...
Would my assumpion correct, if not, what could it be?
How do I "fix" the Sensor(s) (i.e. where are they and all that ****)?
Thanks in Advance.
Just about everytime I hit a bump, I get the magical "Service Stability System" on the DIC. I am pretty sure that it the speed sensor(s) in the *** end of the car.
The questions are...
Would my assumpion correct, if not, what could it be?
How do I "fix" the Sensor(s) (i.e. where are they and all that ****)?
Thanks in Advance.
#12
TECH Fanatic
Thread Starter
iTrader: (8)
Join Date: Jun 2010
Location: Helendale
Posts: 1,921
Likes: 0
Received 0 Likes
on
0 Posts
It as done this before, while under warranty...but that is gone now. So I am hoping to figure this out with get bent over at the dealer.
The last time they said they had to replace a speed sensor, but metioned nothing about the hub being replaced. May just have to jack her big *** up, and poke around in there.
The last time they said they had to replace a speed sensor, but metioned nothing about the hub being replaced. May just have to jack her big *** up, and poke around in there.
#13
I have the same problem and after my tuner scanned it with Tech II, it turned out the driver side rear speed sensor was bad. I checked the plug and connection to it and it's fine but the sensor itself has gone out. Since the sensors are built into the hub you're going to have to replace the whole hub assembly. Best deal I've found is on rockauto.com and it's a timken bearing and hub with the sensor built into it. It runs around $160 for the whole thing and then just give yourself a few hours to pull the hub and swap the new one in.
Just get someone to check it with Tech 2 to figure out which sensor it is after you check for a lose connection, etc..
Just get someone to check it with Tech 2 to figure out which sensor it is after you check for a lose connection, etc..
#15
#16
TECH Fanatic
Thread Starter
iTrader: (8)
Join Date: Jun 2010
Location: Helendale
Posts: 1,921
Likes: 0
Received 0 Likes
on
0 Posts
I have tried it with everything one, T/C off, in Competitive Driving Mode, and with T/C and S/C turned off. It will pop the message and the ABS light will come on with I am backing out of my drive way at 3mph...haha. Damn fickle bitch of a car.
#18
Keep t/c off thought for every drive. The system will eventually pop up a permanent BCM fault and disable itself, hopefully.
#19
TECH Fanatic
Thread Starter
iTrader: (8)
Join Date: Jun 2010
Location: Helendale
Posts: 1,921
Likes: 0
Received 0 Likes
on
0 Posts
Turns on, something just was not seated properly...
I had a little bit of free time (since the government decided I was staying stateside). So I jacked her up, and poked around in her rear. Messed around with the sensors, put her back down...and have not had an issues since. Been about a week now.
I had a little bit of free time (since the government decided I was staying stateside). So I jacked her up, and poked around in her rear. Messed around with the sensors, put her back down...and have not had an issues since. Been about a week now.
#20
Turns on, something just was not seated properly...
I had a little bit of free time (since the government decided I was staying stateside). So I jacked her up, and poked around in her rear. Messed around with the sensors, put her back down...and have not had an issues since. Been about a week now.
I had a little bit of free time (since the government decided I was staying stateside). So I jacked her up, and poked around in her rear. Messed around with the sensors, put her back down...and have not had an issues since. Been about a week now.