When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Comparing a laminate carbon to a new piece made from carbon is also apples to oranges if any one is going to spend money on a carbonfiber part it should be made from carbon fiber not just throw on carbonfiber laminate over existing part
How do I make a mold from a cts trunk to make a carbon fiber trunk?
I would think you'd be much better off going to a dedicated composites forum, like this one, rather than asking in a Cadillac forum where few (if any) people have done what you're asking about.
I would think you'd be much better going to a dedicated composites forum, like this one, rather than asking in a Cadillac forum where few (if any) people have done what you're asking about.
That is soooooo......much nicer than I would have put it!
And if this thread is still somewhat alive then I'd jump in and say this is basically what I would like, but for the V1 instead. Front and side splitters. Perhaps a rear valance of some kind like the AtS-V has.