Starter Guidance
03-12-2018, 10:21 PM
#1
Starter Guidance I am installing my Kooks and I was going to wrap the starter but the wire and the connection area for the small wire crumbled in my fingers. Any ideas? Should I just buy an aftermarket starter while I have it tore down? If so any advice?
03-13-2018, 08:17 AM
#3
A Silverado 6.0L starter is cheap. I got mine from Rock Auto, $50 TYC brand.
You will need to change the terminal to avring terminal connection.
Don't forget to wrap up and relocate the alternator wire with DEI heat sleeve.
May as well do the crank sensor while you are in there if LS2.
-Byron
You will need to change the terminal to avring terminal connection.
Don't forget to wrap up and relocate the alternator wire with DEI heat sleeve.
May as well do the crank sensor while you are in there if LS2.
-Byron
03-13-2018, 04:46 PM
#5
The 5.3 truck starter was the same size as the stock LS2 V1 starter that was on my car when I got it but the 5.3 starter has the ring terminal on it. It installs easily and has worked fine for me.
The 6.0 starter is bigger than the 5.3 or LS2 starter (about 3/8" longer) and I've had a hard time installing those. Yes, that little bit of length made all the difference and I'll never use another one cause I don't need it.
The 6.0 starter is bigger than the 5.3 or LS2 starter (about 3/8" longer) and I've had a hard time installing those. Yes, that little bit of length made all the difference and I'll never use another one cause I don't need it.
03-13-2018, 09:33 PM
#6
The 5.3 truck starter was the same size as the stock LS2 V1 starter that was on my car when I got it but the 5.3 starter has the ring terminal on it. It installs easily and has worked fine for me.
The 6.0 starter is bigger than the 5.3 or LS2 starter (about 3/8" longer) and I've had a hard time installing those. Yes, that little bit of length made all the difference and I'll never use another one cause I don't need it.
The 6.0 starter is bigger than the 5.3 or LS2 starter (about 3/8" longer) and I've had a hard time installing those. Yes, that little bit of length made all the difference and I'll never use another one cause I don't need it.
03-14-2018, 03:10 AM
#7
This is the one I used. Haven't had a single issue with it since install.
I used it with headers and with stock manifold.
I never noticed a difference in size.
I also wasn't thinking to look for one either, I'll keep note if that if I go to a larger headder as something to watch out for.
-Byron
Trending Topics
03-19-2018, 10:41 AM
#9
Went with an Advance Auto starter for a 05 Silverado with the LS engine. It's a little shorter than the stack CTSV model but works just fine. No issues with the install as it slid right in around the UMI mounts and the Kooks headers. I did buy a Jegs starter heat wrap to help with the header temps.