Project : F01
#82
TECH Apprentice
Thread Starter
#87
TECH Apprentice
Thread Starter
Lol I'll ask him price. Uses 3M products and pads.
Resealed them tonight, installed and going for a spin! Oh, wait...
Resealed them tonight, installed and going for a spin! Oh, wait...
Last edited by Ape Man; 12-30-2015 at 07:11 PM.
#88
TECH Apprentice
Thread Starter
Little update :
Got the rust off the block, and got it painted.
Starting March 5 hope to get LS out of the Camaro, get all my parts over into the LQ4 and then get it into the Camaro by March 6.
Pics and update to come!
Got the rust off the block, and got it painted.
Starting March 5 hope to get LS out of the Camaro, get all my parts over into the LQ4 and then get it into the Camaro by March 6.
Pics and update to come!
Last edited by Ape Man; 02-26-2016 at 02:11 PM.
#94
TECH Apprentice
Thread Starter
Thanks guys.
Got frame back in to push car out of shop. Motors are side by side for a part swap. Considering there's no motor the front is lower still haha. Rear stance is perfect. Much better then first day I saw the car.
Got frame back in to push car out of shop. Motors are side by side for a part swap. Considering there's no motor the front is lower still haha. Rear stance is perfect. Much better then first day I saw the car.
#96
TECH Apprentice
Thread Starter
Got the 6.0 out to machine shop. Not taking any chances on reliability with this one.
-New cam bearings
-New crank bearings
-cylinder hone
-new rings if required
Then doing the Trunnion upgrade to rockers.
Cam and valve train already checked out at no harm was done. So once block is back, all parts go on her and back in the car! Getting closer!
-New cam bearings
-New crank bearings
-cylinder hone
-new rings if required
Then doing the Trunnion upgrade to rockers.
Cam and valve train already checked out at no harm was done. So once block is back, all parts go on her and back in the car! Getting closer!
#98
TECH Apprentice
Thread Starter
By next weekend car should be done.
Machine shop is assymbling the short block, then my guys going to get cam/heads etc into it and get it back into the car.
Test fit my lights on weekend (cant wait to get hood on this thing),and got my radio wired and in. So close now.
Machine shop is assymbling the short block, then my guys going to get cam/heads etc into it and get it back into the car.
Test fit my lights on weekend (cant wait to get hood on this thing),and got my radio wired and in. So close now.