95 Z28 6.0 swap
#62
I just got my hands on an LS1 rack and it didn't seem to make much difference. Actually, it looked exactly like the one I took off the car. Maybe somebody swapped in a LS1 rack before I got the car. I may have to buy some of those 1" setback plates since I bought the regulars and the manifolds are hitting the steering shaft.
#66
12 Second Club
iTrader: (23)
Join Date: May 2007
Location: San Antonio, TX
Posts: 652
Likes: 0
Received 0 Likes
on
0 Posts
What did you make for him? its hard to tell on the pics so it looks like an accessory set from a car. I managed to get everything to work with the truck set up but Im wondering if the water pump from a car will work with the truck set up. just so I dont have to deal with moving the water neck
#68
TECH Senior Member
iTrader: (127)
What did you make for him? its hard to tell on the pics so it looks like an accessory set from a car. I managed to get everything to work with the truck set up but Im wondering if the water pump from a car will work with the truck set up. just so I dont have to deal with moving the water neck
Yes u can use the car wp with truck accesories. The solution is to pull the pulley off the shaft about .500
#70
TECH Fanatic
iTrader: (26)
Join Date: Mar 2010
Location: Milledgeville, GA
Posts: 1,909
Likes: 0
Received 0 Likes
on
0 Posts
When putting a carb'd LSX into a LT1 car, what do I need to do to keep my guages working? Not really worried about my speedo, but want my oil pressure, volt, temp, and tach to work.