00byrd

iTrader: (14)

I just installed my NX plate wet kit and was wondering where is a good place to start with the 6010 tune for a 100 shot ? Thanks in advance

00byrd

iTrader: (14)

Sorry N2O....damn night shift

ZONES89RS

iTrader: (25)

Use the directions that come with the kit. It will have a recommended timing amount to pull for what size of a shot you will be using to deduct from total timing. Use the MSDs setup to pull timing when the timing retard wire receives 12 volts.

nova6.2

for 100hp shot dont need retard your initial timing

butler

Pull 4 degrees

LS1MCSS

iTrader: (18)

Yep, or 6, depending on what the plugs look like after a run and what you have the initial timing set at.

S10xGN

iTrader: (11)

For 99byrd, that would be the pink wire...

ZONES89RS

iTrader: (25)

Very unsafe on these motors, the older **** compression motors could get away with it.