Street/Strip LS Coupe
#65
TECH Enthusiast
Thread Starter
iTrader: (2)
Join Date: Jan 2007
Posts: 591
Likes: 0
Received 0 Likes
on
0 Posts
This thing is back under the the knife and headed for the forced Induction section. It’s getting 4.5L Whipple SC makeover in preparation for Drag Week next year<(I don’t think I can have it ready for this year) The new 4.5L Whipple SC is rated @ 1600 HP so if should be fun to drive and super quick if I can control all the low end torque.
Other modifications will include a ERL Super Deck 6 bolt block with a Callies BBC crank cut down for the mains but leaving the BBC rod journals and BBC Ultra Rods. Spark and fuel will come from a Holley Dominator EFI system. I’ll also put in a Chiseled Performance water tank to run ice water through the blower intake intercooler at the track and maybe some higher rear gears... Probably some 3.23’s Great for long trips and help tame some of the torque.
Thanks for the props and following along with me for the Carb version of this project. It was a lot of fun and I hope the next version will be just as successful.
Other modifications will include a ERL Super Deck 6 bolt block with a Callies BBC crank cut down for the mains but leaving the BBC rod journals and BBC Ultra Rods. Spark and fuel will come from a Holley Dominator EFI system. I’ll also put in a Chiseled Performance water tank to run ice water through the blower intake intercooler at the track and maybe some higher rear gears... Probably some 3.23’s Great for long trips and help tame some of the torque.
Thanks for the props and following along with me for the Carb version of this project. It was a lot of fun and I hope the next version will be just as successful.
#66
Motor plates
Do you sell these motor plates. I read in the thread you said you built yours. I would be very interested in purchasing one if so. Great build. Car is beautiful.
Last edited by Reggie67; 03-28-2014 at 02:47 PM. Reason: forgot to add comment