2nd gen fbody, which t56?
#1
Registered User
Thread Starter
iTrader: (2)
Join Date: Jan 2013
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
2nd gen fbody, which t56?
Hi, I'm on the hunt for an LS/t56 pull out. I was looking at at GTO and CTSV pull out, but from reading on here it appears the trans shifter is much farther back on these than the earlier Fbody pull outs. Any advice? Can I use the GTO or CTSV? Would the shifter be too far back and uncomfortable? Thanks for any advice. I want to get it right before making a large purchase.
#3
TECH Senior Member
iTrader: (7)
The easiest T56s to swap into older cars are the F-body and the Magnum T56, followed by the GTO T56 (but it has the 2.97 1st gear set).
The F-body T56s are getting pretty hard to find, since the newest of those cars is going on 13 years old. So if the budget allows it, get the Magnum and call it a day.
Andrew
The F-body T56s are getting pretty hard to find, since the newest of those cars is going on 13 years old. So if the budget allows it, get the Magnum and call it a day.
Andrew
#6
I chopped my GTO shifter in 2 pieces and mounted the one section on the inspection cover near the bellhousing. Then I increased the length of the linkage. Works great.
#7
I'm still digging through some threads so bare with me while i resurrect this one.
Looking to put a T56 in my 78 T/A. Most likely it will be one from a GTO but I may be able to get my hands on an Fbody one.
Question, currently i have a 4speed console (brand new). Id like to utilize that shifter location if possible (farther forward). Do any of you have any photos of your swaps in a 2nd gen using the factory 4speed hole? I'm wondering if i will need to mount the shifter on the forward plate?
Thanks in advance guys
Looking to put a T56 in my 78 T/A. Most likely it will be one from a GTO but I may be able to get my hands on an Fbody one.
Question, currently i have a 4speed console (brand new). Id like to utilize that shifter location if possible (farther forward). Do any of you have any photos of your swaps in a 2nd gen using the factory 4speed hole? I'm wondering if i will need to mount the shifter on the forward plate?
Thanks in advance guys
Trending Topics
#8
TECH Senior Member
See how far to the rear of the block/bellhousing split the shifter is. You will have your answer.