LS7 in a Challenger
i'm sure its possible. couldnt be too hard. Theres alot of room in those engine bays if i remember right. I'm sure people have put SBCs in them. just weld some mounts to the frame and bolt it in lol
Thread Starter
12 Second Club
Joined: Sep 2008
Posts: 158
Likes: 0
From: Denmark
On a challenger the sump of the oil pan is mowed to the foreword because of the steering.. Apposed to GM that almost always have them in the back of the oil pan. Thus, there could be problems concerning the steering of the Challenger because of the dry sump, that even though it's not as deep as conventional chevy wet sump, might interere with the center link.
Anyone ever heard of this swap before?
Anyone ever heard of this swap before?
use the GTO pan.
i will need to see this. if you complete this you need to take it mopar nationals lol.
i always wanted to get an old dart and run a SBC. i dislike mopar and if you can complete this you will be my new hero lol.
i will need to see this. if you complete this you need to take it mopar nationals lol.
i always wanted to get an old dart and run a SBC. i dislike mopar and if you can complete this you will be my new hero lol.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
