iam in the beginning of my swap and wanted to know if anyone is running a procharged ls mustang and if so what kit are you using and how much power is it putting down ????? easy to tune and does the swap fit well ???

thanks jorge

 

There are quite a few forced induciton setups in quite a few cars both efi and carbureted.

 

Do you know if it is custom piping or kits for f-bodys/gtos ???

 

not sure how much room the mustang has, i have an LS/procharged engine in my chevelle, running a carb-i used the vette front setup, but i had enough room in the front b4 the radiator for an air intake, and made up my own piping for the intercooler/intake setup
you can go to Prochargers site, look at the diff kits, see if one looks like it would be close, then just order enough for the basic install, build the rest

 

8lbs of boost for but soon to be 15lbs.Looking at about 750RWHP.

 

what brackets and tubing did you use ?? its a rx7 right

 

Hawks Thirdgen Parts has/had a thirdgen firebird with a LS1 and Magnacharger. Its pretty bad. There is a vid on the website.

EDIT...sorry I should have read better. I see you are looking for a procharger...I was looking around to see what kit would come close to fitting on my thirdgen for while. But decided on a twin screw for future mods.

J.

 

Yes. Go to www.Exotic Performance Plus.com and click on project cars and then scroll down to my rx7.

 

I'm in the stage of putting together an 402 LS1 with a F1A procharger (later) in my 82 Monte Carlo. Can you tell me how street friendly your carb/FI setup is. If its street friendly, I might go that route (plus its cheaper).

 

my carb/procharger setup is real streetable, feels like a reg car just cruising
i spent a lot of time dialing in the carb

 

I was thinking about getting one of those Quick Fuel boost ready carbs. Did you port match your Vic jr to the heads?