aNYONE HAVE ANY PART NUMBERS OR SUGGESTIONS FOR THIS ISSUE?

IM USING A 2004R BEHIND A CARBED LQ4. i WAS TOLD I NEED A BRACKET FOR THE CARB...SO IT WONT BURN UP THE 2004R

HELP!!!!!

 

For a Holley carb, use this one.... There are other brackets you'll need depending on which style cable you go with.

 

thanks S10 do you think you give me a quick run down on how and what this part does..and how the cable is set up and where everything should be bolted or mounted thank you imnot to experienced in this area

 

Here is a link to a good article that you need to read. It will explain a lot about the throttle valve cable on a 200-4R and 700R4.

http://www.chevyhiperformance.com/te.../photo_07.html

 

thanks alot very helpful

 

Before anyone can help you, you need to give specific info. What carb? What manifold? What TV cable? And you really need to buy a pressure gauge setup and check your trans pressures while adjusting the cable.

 

I'm going with a holley 750 mexhanical secondary, GMPP intake, I don't know what tv cable to choose of how to set it up from the trans to the carb. Thanks S10 any part numbers would be extremely helpful.... Also when I adjust the tv cable what readings should I see for the pressure

 

You MUST use this bracket on the carb's throttle linkage, regardless which cable you end up with. If you elect to use a "stock type" kickdown cable, use this bracket. If you go with the Lokar setup, you'll want KD-2200RHT cable, and the SRK-4000 bracket to locate it. Be sure to enlarge the pic on the right side of that page!

The pressure gauge (300# gauge, 4 ft of #4 hose with a #4AN swivel end) installs to the DR side port about 6" above the shifter quadrant. I (permanently) installed a 45° 1/8" NPT x -4AN fitting with a -4AN cap when not in use. Pressure checking info can be found here.

 

so far S10 you've been the biggest help on LS1 tech ..alot of these guys dont know or give the wrong info....i really appreciate it...do u think u could give me some info on setting up the holley fuel pump

 

Dude, go to any of the pump mfg's, they have all the info you need to get started. Try Barry Grant, Holley, Aeromotive, etc. and they'll all have downloadable diagrams and schematics.

 

thx S10 i looked at the lokar setup. If go with these do i still need both of the holley brackets or one of them.Also It shows two cables on the carb..a kickdown and throttle.....so do i need two different cables or just one. Also if there is a need for two what bracket do i use? thanks

 

If you go Lokar, you'll need the Holley '121 bracket for the carb, the Lokar TV cable, Lokar throttle cable, and the Lokar mounting bracket (both cables fit into the bracket).

 

thanks man excellent help

 

what lengths do i need for the throttle and tv cables?

 

They're both universal and need to be cut to fit...