Single Turbo LS1 Notch Build *videos*
#22
11 Second Club
Thread Starter
iTrader: (17)
Join Date: Mar 2005
Location: Maryland
Posts: 4,796
Likes: 0
Received 0 Likes
on
0 Posts
more cutting. doing thru the floor subframe connectors. will tie in to front frame rails and either stop at the rear bulk head or ill tie it in to the rear torque boxes
pass side, all most done cutting
drivers side, still a little bit more cutting needed.
more parts keep showing up at the door,still lots to get, i sold the 31x12x3 intercooler for a 31x12x4 i hope that extra inch of thickness will help lower iats. meth will be used also. erik at hke said hes just waiting on my pushrods then the motor should ship out. still nothing from firefighting1101 on what hes gonna do about the trans bellhousing being broke (ultra bell best way to fix it imo) power coater sent me a pic of the wheel also.
the subframes will tie in to the rear frame so i needed to cut an opening threw the rear bulkhead
pass side, all most done cutting
drivers side, still a little bit more cutting needed.
more parts keep showing up at the door,still lots to get, i sold the 31x12x3 intercooler for a 31x12x4 i hope that extra inch of thickness will help lower iats. meth will be used also. erik at hke said hes just waiting on my pushrods then the motor should ship out. still nothing from firefighting1101 on what hes gonna do about the trans bellhousing being broke (ultra bell best way to fix it imo) power coater sent me a pic of the wheel also.
the subframes will tie in to the rear frame so i needed to cut an opening threw the rear bulkhead
#24
11 Second Club
Thread Starter
iTrader: (17)
Join Date: Mar 2005
Location: Maryland
Posts: 4,796
Likes: 0
Received 0 Likes
on
0 Posts
few minor up dates. i got a silicone elbow that i needed and i sold my 3" intercooler and got a 4" intercooler. looks so much bigger. so i connected the turbo to the intercooler.
#29
11 Second Club
Thread Starter
iTrader: (17)
Join Date: Mar 2005
Location: Maryland
Posts: 4,796
Likes: 0
Received 0 Likes
on
0 Posts
off ebay
GOT MY MOTOR!
update.
thru floor frame connectors are done!
battery box is mounted
made my own rear bumper support
getting the motor all buttond up, should be able to go in the car on sunday, then ill make the hot side and finish the cold side.
i got 80 some days till the ocean city show
#40
TECH Apprentice
iTrader: (6)
Join Date: Aug 2009
Location: se wi.
Posts: 323
Likes: 0
Received 0 Likes
on
0 Posts
what year engine is that?(short or long crank) what flex plate did you use? did you have to use a spacer for it? the converter your using is it set up for a th400-ls1?
sorry for all the questions. I'm trying to figure out if i have the correct parts to put mine together with.
sorry for all the questions. I'm trying to figure out if i have the correct parts to put mine together with.