slownova73

iTrader: (31)

http://www.stevesnovasite.com/forums...d.php?t=140303

theres the thread, just notch the brackets to clear the core support for when they are slid back, and drill new holes, and bam!

twin74s

iTrader: (10)

Got my exhaust built finally. Here is a pic of the drivers side... My phone died today so no pic of the other side til tomorrow.

twin74s

iTrader: (10)

Got my cam and valve springs installed tonight. Getting closer!

-TheBandit-

iTrader: (1)

Did you use new torque-to-yield fasteners?

twin74s

iTrader: (10)

Like? i converted it to 3 bolt cam and used ARP bolts. Besides that i'll reuse everything else.

1972nova

iTrader: (13)

love the dash setup

-TheBandit-

iTrader: (1)

I've read that the bolts holding the phaser and/or timing set were torque-to-yield and therefore not reusable. Sounds like you went to a non vvt cam so it's a mute point.

ace ventura

could you please tell me the specs on the wheels are you using spacers what bolt patern are they bmw 5x120 not chevy 5x120.65 or 5x4 3/4 sure would apreciate the help

twin74s

iTrader: (10)

after two weeks of messing with it a very helpful local shop got it running today. hoping for dyno time this weekend!

-TheBandit-

iTrader: (1)

Did you find out what the problem was? Wiring? Flash? Other?

twin74s

iTrader: (10)

yes starter enable wire needs to be grounded or starter check needs to be disabled in the PCM. Either will allow it to start.

ace ventura

I will be getting these wheels for my ventura they do come in 5x4 3/4 just got to check out that back spacing havent seen a nova be able to fit a 275 tire in the front you should put this car on pro touring .com a lot of peopple would be interested in the wheels and the build sweet fng car

twin74s

iTrader: (10)

Thanks mine has 285's on the front now and they barely rub... Im going down to a 245 front tho as i dont think much bigger on a 8.5 wheel will look good.

71 chevy

iTrader: (18)

in for dyno.

twin74s

iTrader: (10)

Doing some street tuning monday night and final dyno tune next saturday. Im excited!

twin74s

iTrader: (10)

I've put almost 700 miles on it so far. Work got slow so im waiting on dyno money and changing the rear syspension back to leaf springs. Ill try to get some pics up later of it cleaned up and outside.

-TheBandit-

iTrader: (1)

What suspension system are you replacing with leafs and why?

twin74s

iTrader: (10)

Right now it has a torque arm setup in it. Lower control arms go to the stock leaf spring front mounts, custom built torque arm runs in the tunnel up to just behind the trans to its own cross member and has a panhard bar off the pass frame rail to the housing and has coil overs in front of the axle. It all works really good but being all solid heims it's really loud.

Black FormulaLs1

iTrader: (10)

love the novas but you cant find one up here in NY worth building anymore..maby come tax return time i can get one..but i LOVE the lsx swaps. FINE JOB SIR!!!

twin74s

iTrader: (10)

Well i put about 3k miles on it this year, now time to go under the knife for a few more mods before spring and i plan on driving this thing DAILY for the better part of 2011! woot