Anyone have a NON spring loaded LS1 belt tensioner?
#1
Anyone have a NON spring loaded LS1 belt tensioner?
I'm looking for a non spring loaded belt tensioner for my 2001 LS1. I'm using F body brackets with a home made A/C bracket all run on the same belt, but the compressor slips. If you manually put more tension on the tensioner, it works fine. I have almost 3/4 belt wrap around the compressor, so that's not the problem, and I've tried shorter belts, but they are nearly impossible to get on they're so tight. Anybody have any idea where I could find such a thing???
#3
TECH Addict
iTrader: (57)
They had a 15% special going on thru facebook too, its in the sponsor sales section. https://ls1tech.com/forums/sponsor-s...week-only.html
#4
TECH Addict
iTrader: (22)
Word of caution about fixed/adjustable tensioners. You do not have a V-belt setup, serp belts stretch and a static tensioner will allow the belt to loosen as it stretches and your slipping problem will get worse. When you shut the engine off and load on the belt returns to zero it will appear tight once again. Watch a dyno video and the tensioner will dance quite a bit regardless of engine type
If the tensioner movement is not fluid it needs to be replaced. If the belt is slack, get a shorter one
http://www.goodyearep.com/ProductsDetail.aspx?id=3128
If you cant find the proper size belt in there, you're doing it wrong
If the tensioner movement is not fluid it needs to be replaced. If the belt is slack, get a shorter one
http://www.goodyearep.com/ProductsDetail.aspx?id=3128
If you cant find the proper size belt in there, you're doing it wrong
#7
TECH Enthusiast
iTrader: (19)
you do have to watch them and check/ retighten more than an old v-belt setup, but not to the point of being crazy. There are a lot of fixed tension point serpentine belt setups out there. My dealings so far have just been that they need a little attention upon first setup as they usually stretch pretty quickly. After that its a matter of checking up on it once in a while.
Trending Topics
#10
TECH Enthusiast
My vintage air setup is also screaming like a witch, and i have a good wrap on the compressor as well. I tried lowering the pressure in the system but now it does not blow too cool and occasionally screams , so i guess i will try what you did to see if that is the problem. never would have thought that was the problem. JOHN
#11
My vintage air setup is also screaming like a witch, and i have a good wrap on the compressor as well. I tried lowering the pressure in the system but now it does not blow too cool and occasionally screams , so i guess i will try what you did to see if that is the problem. never would have thought that was the problem. JOHN
An easy was to test if it will work for you is to put a 15mm wrench on the tensioner when it's screeching and pull down on it there for putting a little more tension on the belt, if that stops it, then the adjustable tensioner should aleviate the problem. When I first put it on it screeched, but with the engine running I loosened the bolt that holds it tight, then with a ratchet (there's a square hole for it) put just enough tension on it to stop the squeal, then tightened it back up. Haven't heard a peep out of it since.