Upright Ignition Coil Brackets - Do these look better?
#21
TECH Junkie
iTrader: (12)
Join Date: May 2002
Location: Burleson/Ftw,Texas
Posts: 3,420
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
My Pace coil covers came in today. The modification is not to bad. It was about an hour or so worth of work. Here is a post in my build thread with pictures:
https://ls1tech.com/forums/14289194-post75.html
https://ls1tech.com/forums/14289194-post75.html
#22
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Unwrapping these things totally sucks because the tape they wrap them with is petrified to a concrete hardness.
#26
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
They are installed already, but I will take them off again when the motor goes in. It is nothing to terribly complex, you just need the proper colored wire and a good soldering set up. Just unwrap the harness, route the wires where you want them, lengthen the ones that don't reach, shrink wrap the new connections and then re-wrap it with high quality electrical tape. The big pain is the damn tape that came from the factory turns into a brittle mess that has to be picked off in pieces in some places. Time consuming and annoying more than anything.
#28
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Glad to see someone used a dual plane mani.