Hydroboost intake plug part number?
Hydroboost intake plug part number? Does anybody know the part number for the plug that goes in the back of the intake on a hydroboost equipped truck (LQ4)? Mine has the nipple for the vacuum brake hose, and I want to delete it. My search turned up nothing. Thanks.
...or try looking at CompNine.com. They have all sorts of part numbers for things I can't find anywhere else. I usually take those to the dealer and buy what I need. Of course a quick spin didn't turn up what you are talking about, but I'm at work.
I went to Westfall GMC, but the problem is I don't know exactly what it's called. the guy there looked alot, and I did find the nipple for the power brake hose to hook to,it was only like $5, but can't find the plug.
h
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Im sooo close to getting mine runnin.....
The LS4 guys swaping to the LS1 intake use a 1 31/32" freeze plug:
Next remove the rear vacuum fitting
Take a hacksaw and saw the fitting off and then pry the rest of the fitting out with a flat blade screwdriver,
Here is what you'll end up with
Next plug the hole with a 1 31/32" freeze plug using 3M weatherstripping adhessive or epoxy. Then drill a .441" hole in the lower corner and mount the MAP sensor with a small screw. I used adhessive to seal the screw too.
Very tight fit!
Take a hacksaw and saw the fitting off and then pry the rest of the fitting out with a flat blade screwdriver,
Here is what you'll end up with
Next plug the hole with a 1 31/32" freeze plug using 3M weatherstripping adhessive or epoxy. Then drill a .441" hole in the lower corner and mount the MAP sensor with a small screw. I used adhessive to seal the screw too.
Very tight fit!
Truck intakes are a little different, the plug just pushes in. Thanks anyway though.
van had hydra boost on it so I adp. it to the chevelle. But I had to change the intalke to a trk one to get a cover for it.....If i can help let me know... going to be up at the KCI cruise tonite.. hope to see ya.....
Rick
Rick
It's off of I-29 by the airport at the old Farmland building. You were probably thinking the dragstrip, huh? Couldn't be that close. You should consider going it's usually a good show.
plug are you talking about the one for the truck intake that goes in the rear and has the red retainer ring to hold it in, one is a plug and then there is one for a hose if so i have some of them pm me thanks mike
