I was wondering if anyone knows what type of crimp connector will fit on the wire to plug these two into the switch? The regular female connector for the spade is too large. I measured the width of the connector and it is 1/10th of an inch.

Thanks for any help.

 

I use solder on the wires. Try Auto Zone or Advance

 

funny, I did wind up soldering the wires.

 

I have a retro ride car (68 camaro body on a 2002 camaro chassis) I I want to use the original brake lights for 68 camaro do I splice off the relay or the switch on the pedal, which is the 2002 camaro switch set up shown in the pics'. Need some advice? Tks..

 

If you have that switch,just wire it as shown,no need for a relay.

 

If all slots are occupied on the brake switch which ones to I use for the 68 brake harness?

 

The 68 brakes came directly off the pedal switch. If the right hand switch terminals in the pic above are occupied they must be controlling the brake relay on the 2002. So tie your 68 brakes to the brake relay.