Stainless Works LS Swap Headers
02-24-2012 | 06:39 PM
#42
On The Tree
Joined: Dec 2007
Posts: 108
Likes: 0
From: Harrison Arkansas
Custom long tube? Paul,
Can/will you guys duplicate a set of home built headers in stainless? I've made some for my 36 Chevrolet Low Cab out of mild steel and while they will function fine when I'm done I just don't think they will look right with all the welded joints even with a high temp coating.
If the answer is yes, would you rather I didn't fully tig the primary's to the flanges so they are easily removable? There are quite few bends to make these as close to equal length as possible. I'll get a picture when I can get to the shop. Here's a picture of the space I had to work with when I first started up the mock up.
Have to switch computers to add the pic.....da** IPad!
By the way, a quick scheme for advertising or not, this is the sort of thing we need sometimes. Alot of good can come from this thread over time. You guys with Fbodys, Gbodys, etc have it made for room. Try stuffing one of these jewels in a pre-war era car/truck without going with tight tucks. LOL's.
Stovebolter
Can/will you guys duplicate a set of home built headers in stainless? I've made some for my 36 Chevrolet Low Cab out of mild steel and while they will function fine when I'm done I just don't think they will look right with all the welded joints even with a high temp coating.
If the answer is yes, would you rather I didn't fully tig the primary's to the flanges so they are easily removable? There are quite few bends to make these as close to equal length as possible. I'll get a picture when I can get to the shop. Here's a picture of the space I had to work with when I first started up the mock up.
Have to switch computers to add the pic.....da** IPad!
By the way, a quick scheme for advertising or not, this is the sort of thing we need sometimes. Alot of good can come from this thread over time. You guys with Fbodys, Gbodys, etc have it made for room. Try stuffing one of these jewels in a pre-war era car/truck without going with tight tucks. LOL's.
Stovebolter
Last edited by Stovebolter; 02-24-2012 at 06:52 PM.
02-24-2012 | 07:47 PM
#44
03-28-2012 | 02:10 AM
#46
We've been begging Bruce for 1 7/8 for a while, but he's been non-responsive. I suspect that he gets bombarded with so many requests for products that would ultimately never sell that he's reluctant to take on something new. I emailed SW a few months ago asking if they would build me a set that I could buy through them or Hawks, and never received a response.
